Audi AMB - Page 131

12 - Bearing cap for intake camshaft
 Must be located on dowel sleeves
 Dowel sleeves must be located in cylinder head
 Note installed position
 Installation sequence
13 - Double bearing cap
 Must be located on dowel sleeves
 Dowel sleeves must be located in cylinder head
 Apply small amount of AMV 188 001 02 to sealing surface before installation
 Sealing transition points between double bearing cap and cylinder head Sealing transition points
between double bearing cap and cylinder head (2 points):
14 - Exhaust camshaft
 Check radial clearance with Plastigage™ (valve lifters not installed): Wear limit: 0.1 mm; Run-out: max.
0.035 mm
 Checking axial clearance --> Camshaft axial clearance, checking
 Removing and installing camshafts --> Camshafts and camshaft adjuster, removing and installing
15 - Bearing cap for exhaust camshaft
 Must be located on dowel sleeves
 Dowel sleeves must be located in cylinder head
 Note installed position
 Installation sequence
16 - 10 Nm
17 - 10 Nm
18 - Drive chain
 Check for wear
 Mark position of chain before removing Clean chain and camshaft sprockets opposite two under
Removing
 Removing and installing --> Camshafts and camshaft adjuster, removing and installing , Camshaft,
removing and installing
19 - Camshaft ad
j
uste
r
2005 Audi A4 Quattro
ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
1:01:03 AM Page 119
cardiagn.com