Audi AMB - Page 82

5 - Gasket
 Replace
6 - Cylinder block
 Removing and installing crankshaft --> Crankshaft, removing and installing
 Disassembling and assembling pistons and connecting rods --> Pistons and connecting rods,
disassembling and assembling
7 - Securing bolt for dual-mass flywheel/drive plate
 Replace
 Tightening torque for dual-mass flywheel: 60 Nm + 1/2 turn (180 ° ) further
 Tightening torque for drive plate (vehicles with automatic transmission): 60 Nm + 1/4 turn (90 ° ) further
8 - Dual-mass flywheel/drive plate
 Removing and installing dual-mass flywheel --> Dual-mass flywheel/drive plate, removing and
installing
 Removing and installing drive plate
9 - Intermediate plate
 Must be located on dowel sleeves
 Do not damage/bend when installing
10 - 10 Nm
11 - Rear sealing flange
 With oil seal
 Remove oil pan to remove and install --> Oil pan, removing and installing
 Replace only as complete assembly
12 - Oil seal
 Replacing --> Crankshaft oil seal - pulley end, replacing
13 - Intermediate shaft
 Axial clearance max. 0.25 mm
14 - O-ring
2005 Audi A4 Quattro
ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
1:00:58 AM Page 70
cardiagn.com