Audio enhancement K-SRC14 - DIP Switch Settings

15
Rev.2.10
DIP switch setting
switch
No
Name
Function
Off
On
Switch1
1
MIC OVERRIDE
Selection of microphone override function
Deactivated
Activated*
2
TONE ON/OFF
Selection of tone signal from this unit at
operating volume button of K-STD14
Tone OFF
Tone ON*
3
Tone Level H-L
Selection of tone signal (2 levels) at operating
volume button
Low level*
High level
4
MIC/LINE MIX
Microphone/Line Mixing
Selection of whether to mix the microphones
MIC1 and MIC2 to the mixing output (Line Out)
Mixing
deactivated
Mixing
activated*
5
F/B BLOCKER
Feedback Blocker setting
Selection of feedback blocker function
Feedback
blocker
deactivated*
Feedback
blocker
activated
6
RMT VOL
Remote Volume setting
By selecting the remote volume function,
normal mic buttons will be reassigned. When
this switch is set to ON, the volume control of
this unit using the volume button of K-STD14
will be deactivated.
This setting is intended to control an external
device using the volume button of K-STD14
through the serial communication command.
Mic buttons
normal*
(as labeled)
Mic buttons
reassigned
7
Mix OUT-ATN
Attenuation of audio output of the mixing
output (–10 dB)
ATT
deactivated
ATT effective*
8
Tx Pwr Normal/Hi
Selection of transmission output control
NORMAL*
HIGH
Switch2
1
CH3 Vol Line/Mic
Allows the teacher microphone to control
volume for the media channel
Deactivated
Activated
2
AP GROUP bit5
3
AP GROUP bit4
4
AP GROUP bit3
AP Group ID setting
0-127 of Group ID
5
AP GROUP bit2
6
AP GROUP bit1
7
AP GROUP bit0
8
WAP
AP connect
Off*
AP connect
on
*default setting
Default setting
Switch1
Switch2