Need help?Do you have a question about the Audio Pro A4.14 Zero and is the answer not in the manual?
Remove the A4.14 from the carton and be careful not to damage any driver. Save the carton for later use.
Connect the A4.14 to a mains outlet. Only the 230V version is available in Europe.
System automatically activates with audio signal and enters standby after 5 minutes of no signal.
Connect the A4.14 to a preamplifier or speaker outputs using the enclosed RCA cable.
Adjusts sensitivity and input level. Ensure control is set equally for both speakers.
Adjusts power spectrum below 300 Hz based on room placement and calibration angles.
Optimizes high frequency output based on room absorption and composition.
To Next Page
General