Need help?Do you have a question about the Audio Research SP16 and is the answer not in the manual?
Allows adjusting the volume level using up and down buttons.
Selects between five single-ended input sources via LED indication.
Supplies AC power to the unit, defaults to 'off' on power restoration.
Shorts outputs to mute, LED indicates mute status.
Bypasses controls for external surround processor, defaults to stereo.
Flashes during automatic muting cycle, then indicates mute status.
Procedure to drain static charge and reset controls if inoperable.
Front panel functions duplicated on remote, includes stereo/mono switch.
Six sets of Single-Ended (SE) inputs for various sources.
Two sets of single-ended output connectors for amplifiers.
Outputs for connecting to tape deck inputs for recording.
Provides control voltage for remote start relays in amplifiers.
Ensures proper operation by detailing placement on stable surfaces and ventilation needs.
Advises against stacking on amplifiers to prevent overheating and hum.
Emphasizes the necessity of installed covers for safety and interference shielding.
Steps for connecting and powering on the unit.
Steps for safely powering off the unit and connected components.
Details on compatible moving magnet and MC cartridge outputs.
Procedure for using the unit for recording and dubbing.
Explains automatic muting during warm-up and power interruptions.
Using the Mute/Operate switch for protection during switching.
Instructions for cleaning the front panel and unit.
Specifies frequency response for line and phono inputs.
Details distortion levels at rated output.
Lists gain values for different modes and outputs.
Specifies input impedance for line and phono.
Details output impedance for main and record outputs.
Confirms output polarity is non-inverting.
Specifies maximum input voltage for line and phono.
Defines rated output voltage and maximum output.
Lists front panel buttons and remote control functions.
Describes power supply regulation and mute features.
Specifies noise levels for main output and phono input.
Specifies 12V DC output for system power control.
Lists the type and number of vacuum tubes used.
Details voltage, frequency, and power consumption.
Provides physical dimensions of the unit.
Specifies net and shipping weight.
General| Type | Preamplifier |
|---|---|
| Weight | 25 lbs |
| Total Harmonic Distortion | Less than 0.01% at 2V output |
| Input Impedance | 100k ohms |
| Output Impedance | 600 ohms |
| Dimensions | 19 x 5.25 x 15.75 inches (WxHxD) |
| Tube Complement | 2 x 12AX7 |
| Inputs | 4 x RCA |
| Outputs | Main, Tape |
| Signal-to-Noise Ratio | > 100 dB |
To Next Page