What to do if my Audio Technica ATUC-50DUA cannot turn on?
If your Audio Technica Conference System won't power on, first ensure the AC power cord is securely connected. Also, verify the connection to the Control Unit (CU) or any other Discussion Units (DUs) or Interface Units (INTs).
What to do if no sound is output from the headphone jack of my Audio Technica ATUC-50DUA?
If no sound comes from the headphone jack of your Audio Technica Conference System, first, ensure the headphone plug is fully inserted. If that doesn't work, try raising the volume using the + button. Finally, use the monitor channel selection buttons on the DU/INT to confirm you can monitor speech from the desired channel.
How to fix Audio Technica ATUC-50DUA Conference System when it cannot turn on?
If your Audio Technica Conference System cannot turn on, ensure the AC power cord is properly connected. Also, check the connection to the CU or other DUs/INTs, verify the installation of the rechargeable batteries, and check the remaining charge in the rechargeable batteries.
Why is there no sound from the built-in speaker on my Audio Technica ATUC-50DUA Conference System?
If the sound from the built-in speaker of your Audio Technica Conference System is not working, check the connection of the DUs and ensure the Ethernet cable is fully plugged in. Also, check the cables for damage. In the settings, verify that the [Speaker] setting is set to [Enabled]. Finally, adjust the speaker level.
What to do if the connected microphone does not work on my Audio Technica Conference System?
If the connected microphone of your Audio Technica Conference System isn't working, ensure the microphone is properly connected. Also, check and adjust the MIC/LINE 1/2 settings.
Why is the sound distorted from the connected speaker on my Audio Technica ATUC-50DUA Conference System?
If the sound from the connected speaker of your Audio Technica Conference System is distorted or cannot be heard, verify the connections of all devices, ensure the connection cables are fully plugged in, and check that the inputs and outputs of all devices are properly connected. Also, check that terminal pin assignments are correct and that the cables are not damaged. Finally, check and adjust the setting of the connected amplifier.
How to fix Audio Technica ATUC-50DUA Conference System when it cannot get recognition from Dante controller?
If your Audio Technica Conference System cannot get recognition from the Dante controller, check the connections of the LAN cables and the Dante network settings.
Why does the (talk) button not function on my Audio Technica Conference System?
If the (talk) button on your Audio Technica Conference System does not function, it may be due to the conference mode or setting. Check the conference mode settings and the settings of the interpretation unit(s).
What to do if my Audio Technica ATUC-50DUA cannot record sound?
If your Audio Technica Conference System does not record sound, check the remaining memory on the USB device (mass storage device). You may also need to reconnect the USB device or try a different one.
Why is Dante audio not being input into my Audio Technica Conference System?
If Dante audio is not being input into your Audio Technica Conference System, verify that the audio routing on the Dante controller is correct and that the input audio settings on Web Remote are correct. Ensure “DANTE” is selected as the type for input settings.
General| Number of Connectable Units | 50 |
|---|---|
| Sampling Frequency | 48 kHz |
| Quantization | 24-bit |
| Frequency Response | 20 Hz - 20 kHz |
| Headphone Output | 3.5 mm stereo mini-jack |
| Type | Digital Conference System |
| Frequency Range | 2.4 GHz |
| Audio Channels | 2 |
| THD | < 0.1% |
| Dynamic Range | More than 100 dB |
| Recording | USB |
| Channels | 2 |
| Connector | USB |
| Power Supply | 100-240 V AC, 50/60 Hz |
To Next Page
