Audio Technica ATW-1701 Assembly And Set-Up

Audio Technica ATW-1701 Wireless Mic System – Assembly & Setup
In the box you should have the following:
• Belt Pack Transmitter
• Wireless Receiver
• Bracket
• XLR to Mini Jack Cable
• USB charging cable
• HT Aeromic
1. Slide the bracket’s clip into the mount on the side of the Bose
system, noting the directional arrows on the bracket.
2. Tighten the circular screw using thumb and fore finger, until the
clip feels secure, being careful not to over tighten.

Audio Technica ATW-1701 Specifications

Operating Environment

operating frequencies	2.4 GHz ISM band
operating range radius	30 m (100')
operating range diameter	60 m (200')
operating temperature range	0° C to +40° C (32° F to 104° F)
charging temperature range	5° C to +35° C (41° F to 95° F)

Receiver Specifications

maximum output level	+6 dBV
monitor output level	70 mW +70 mW (32Ω)
power supply voltage	100-240V AC (50/60 Hz) to 5V DC 0.5A
internal battery voltage	3.7V
battery life	12 hours
battery charging time	4 hours 30 minutes
dimensions	56.0 mm W x 91.4 mm H x 27.8 mm D
net weight	105 grams

UniPak Transmitter Specifications

rf output power	10 mW
battery life	>7 hours (alkaline)
dimensions	70.2 mm W x 107.0 mm H x 24.9 mm D
net weight without batteries	100 grams

Handheld Transmitter Specifications

rf output power	10 mW
battery life	>7 hours (alkaline)
dimensions	254.8 mm long, 50.0 mm diameter
net weight without batteries	280 grams