What to do if the diagnostic LED is illuminated on my AudioBahn Amplifier?
If the diagnostic LED is illuminated, it could indicate a speaker short or the AudioBahn Amplifier overheating. Check these potential issues to resolve the problem.
How to troubleshoot if the power LED is not illuminated on my AudioBahn Amplifier?
If the power LED on your AudioBahn Amplifier isn't illuminated, try the following: Check the fuses in the amplifier, ensure the turn-on lead is connected, verify the signal leads, check the gain control, confirm the tuner/deck volume level, and clean the contacts on the fuse holders.
What to do if the fuse is broken in my AudioBahn Amplifier?
If you find that the fuse is broken, the solution is to replace it.
What to do if my AudioBahn Amplifier experiences a temperature shutdown?
If your AudioBahn Amplifier is experiencing a temperature shutdown, try turning the radio volume down.
What to do if there is no power to the power wire of my AudioBahn Amplifier?
If there is no power to the power wire, you should repair the power wire or its connections.
What to do if there is no power to the remote wire with receiver on my AudioBahn Amplifier?
If there is no power to the remote wire with the receiver on, check the connections to the radio.
How to check speaker leads on AudioBahn Amplifier?
Inspect the speaker leads for a short circuit or an open connection.
How to check audio leads on AudioBahn Amplifier?
If you need to check audio leads, reverse the left and right RCA inputs to see if the issue occurs before the amp.
What to do if speaker wires are shorting on my AudioBahn Amplifier?
If speaker wires are shorting, separate them and insulate them.
General| Channels | 1 |
|---|---|
| THD at RMS Output | < 0.1% |
| Signal to Noise Ratio | > 100 dB |
| Damping Factor | > 200 |
| Input Sensitivity | 200 mV - 6 V |
| Low Pass Filter | 50 Hz - 250 Hz |
| Bass Boost | 0 dB - 18 dB |
| Minimum Impedance | 1 Ohm |
| Crossover Frequency | 50 Hz - 250 Hz |
| Power Output (RMS) | 1500 Watts |
| RMS Power @ 4 Ohms | 500 Watts |
| RMS Power @ 1 Ohm | 1500 Watts |
| Max Power | 3000W |
| Frequency Response | 10 Hz - 250 Hz |
To Next Page
