Audiocom MS-2002 - Page 10

10
Switch # Description Settings Default
DIP SWITCH SW1 (INTERNAL)
SW1-1 Headset Microphone Type
On: Unbalanced
Off: Balanced
Off
SW1-2 Call Signal Send, channel 1
On: Enabled
Off: Disabled
On
SW1-3 Call Signal Receive, channel 1
On: Enabled
Off: Disabled
On
SW1-4 Call Signal Send, channel 2
On: Enabled
Off: Disabled
On
SW1-5 Call Signal Receive, channel 2
On: Enabled
Off: Disabled
On
SW1-6 Mic Kill Signal Send
On: Enabled
Off: Disabled
Off
SW1-7 Program 2
On: Interrupt During Talk
Off: No Interrupt
Off
SW1-8 Program 1
On: Interrupt During Talk
Off: No Interrupt
Off
BALANCED (BAL) - UNBALANCED (UNBAL) OPERATION
BOTH SWITCHES MUST BE SET THE SAME
FACTORY DEFAULT IS BALANCED
Rear Panel Audiocom or Clear-Com operation
Out: Balanced (Audiocom)
In: Unbalanced (Clear-Com)
Out (BAL)
Rear Panel Audiocom or Clear-Com operation
Out: Balanced (Audiocom)
In: Unbalanced (Clear-Com)
Out (BAL)
DIP SWITCH SW3 (INTERNAL)
*S
ET ALL TO MONAURAL OR ALL TO BINAURAL
SW3-1 Incoming Call Beep
On: Disabled
Off: Enabled
Off
SW3-2* Listen 1 to speaker 1 only
On: Enabled (Binaural)
Off: Disabled (Monaural)
Off
SW3-3 Incoming Call Beep, Speaker 1
On: Enabled (SW3-1 must be OFF)
Off: Disabled
Off
SW3-4 Incoming Call Beep, Speaker 2
On: Enabled (SW3-1 must be OFF)
Off: Disabled
Off
SW3-5 Listen 2 to Right Headphone
On: Enabled (Monaural)
Off: Disabled (Binaural)
On
SW3-6 Listen 2 to Speaker 1
On: Enabled (Binaural)
Off: Disabled (Monaural)
Off
SW3-7 Listen 2 to Speaker 2
On: Enabled (Monaural)
Off: Disabled (Binaural)
On
SW3-8 Listen 1 to Left Headphone
On: Enabled (Monaural)
Off: Disabled (Binaural)
On
TABL E 1. Configuration Switch Table