D
El
D
D
El
D
fl
B
Quick
setup
Connect the included speaker wire from
your
passive speakers
to
the
N22,
observing proper wire polarity
to
each speaker connec-
tor.
Verify
that
the
volume/power
knob on the rear panel
of
the
left
speaker
is
in the
OFF
position by rotating the knob until
it
clicks
off.
Connect
the
AC
power cable
to
the
N22
rear panel and plug the
other
end
of
the cable into a functioning power outlet.
Wireless
connection
Turn power on via the
front
panel
volume/power
knob.
N22
will
automatically go into Bluetooth "pair mode" and the Pair
button on the
front
panel will start flashing.
On
your
device (phone, tablet, computer, etc) turn on Bluetooth
and go
to
Bluetooth preferences.
Select "Audioengine N22"
to
pair and connect. The Pair indicator
light on the
N22
front panel should now be on solid.
Play
your
music and adjust volume levels
for
N22
and
your
device.
To
add additional devices
put
N22
back into pair mode by
disconecting
N22
from
your
device
or
by pressing the Pair button
on
the
N22
front
panel
for
about 3 seconds
until
the pair indicator
light starts flashing. Repeat steps 2 & 3
to
connect another device.
N22
wirelessly connects
to
one device
at
a time, however
it
will
pair and remember up
to
six different devices.
To Next Page
Loading...
