audiolab DC Block
Mains Conditioner (DC+RF filter)
Important Safety
Information
Warranty Coverage
Quick Instruction Guide
Functions：
2. Blocks DC on the mains power line.
Unpacking:
U npack the product fully, the carton should contain:
• The audiolab DC BLOCK
One IEC mains power cord suitable for your area
One IEC C14 to C13 jumper cord
•
•
2: audiolab DC Block - Mains Conditioner (DC+RF filter)
Page 3
Specifications:
Power Requirement:
*Peak Load:
100-240V ~ 50-60Hz
600VA
< 2x150W or < 1x300W
113 x 59 x 140 (mm)
0.7kg
If an item is missing or damaged report this to your dealer as soon as possible.
Retain the packing for safe transport of your unit. If you dispose of the packing,
do so with regard to any recycling regulation in your area.
Connection:
before the operations below.
Dimensions (W x H x D):
Weight (net):
*Note
Connect the supplied jumper cord from the output of DC BLOCK to the unit
Connect the supplied mains power cord from the input of DC BLOCK to the
AC supply outlet
(1)
(2)
(1)
(2)
:
The DC BLOCK is designed for audio equipment with variable power requirements
up to maximum peak load, and should not feed any permanent high power loads
such as heaters or similar.
To Next Page
Loading...