Verifit
®
User's Guide Version 3.12
November 2015
255.255.255.0 in the Subnet mask box.
6. On the Verifit, un-check Auto (use DHCP) on the Setup network screen and click the Change button. Then
set the network addresses as shown below by clicking on the down arrow buttons and selecting from the
drop-down lists.
7. On the Verifit, uncheck Auto on the Setup network screen and click the Change button. Then set as shown
below by clicking on the down arrow buttons and selecting from the drop-down lists.
8. Select [Continue].
9. Click on the Test button to check that a connection has been established.
31
To Next Page
Loading...
