Need help?Do you have a question about the Audiotec Fischer Match PP 52DSP and is the answer not in the manual?
General| Output Channels | 4 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 100 dB |
| THD | < 0.05% |
| Damping Factor | > 100 |
| High-Level Input | Yes |
| Low-Level Input | Yes |
| Input Channels | 4 |
| Amplifier Class | D |
| Input Impedance | 10 kOhm |
| Input Voltage | 12 V |
| Features | Bluetooth, USB |
| Power Output | 4 x 50W (4Ω) |
Read manual carefully, disconnect battery, install in dry location with air circulation, secure properly.
Use negative ground system, provided MATCH cable only, plan wire routing, protect cables, use correct fuse.
Access website, download setup, transfer to microSD, insert into amplifier.
Steps to connect the amplifier to the car radio using the MATCH cable harness.
Details connecting via vehicle harness or directly to the battery.
Guide to setting amplifier gain using radio volume and MODE switches.
Steps to download, install, and connect the amplifier to the PC for configuration.
Overview of the ATF DSP PC-Tool interface for device configuration and channel settings.
To Next Page
