Do you have a question about the Audiovox Advent and is the answer not in the manual?
Unplug the subwoofer before cleaning with a damp cloth. Avoid liquid or aerosol cleaners.
Do not use attachments not recommended by Advent, as they may cause hazards.
Do not use the subwoofer near water or in wet locations like bathrooms or pools.
Do not place on unstable surfaces; use only Advent-recommended stands or tables.
Ensure ventilation slots are not blocked to prevent overheating.
Operate only from the type of power source indicated on the label.
Ensure correct plug grounding and polarization for safety.
Route power cords to prevent them from being walked on or pinched.
Unplug during lightning storms to prevent damage from surges.
Do not overload outlets or cords to prevent fire or shock hazards.
Never push objects into openings or spill liquid on the product.
Do not attempt self-servicing; refer all repairs to qualified personnel.
Unplug and refer to service if cord, liquid, water, or performance issues occur.
Ensure only Advent-specified replacement parts are used by technicians.
Ask technicians to perform safety checks after service or repairs.
Keep the subwoofer away from heat sources like radiators and stoves.
Check system for transit damage and observe all warnings and cautions.
Do not expose the subwoofer system to rain or excessive moisture.
Receiver volume control does not indicate overall loudness; focus on system level.
Always turn off all equipment when changing cables or plugs to prevent transients and shock.
Do not open the subwoofer; there are no user-serviceable parts inside.
Place the subwoofer on the floor, preferably in a corner, for proper function.
Plug the power cord into an AC outlet capable of supplying at least 200 Watts.
Controls AC supply ON/OFF and AUTO ON standby mode based on audio signal detection.
LED shows power status: unlit (OFF), red (standby), green (ON).
Fuse protects against faults; replace only with the same type and current rating.
Terminals for speaker wire connections; use only with Option 1.
Jack for low-level mono sub signal input using audio cables; use only with Option 2.
Adjusts the upper frequency limit for audio signals to the subwoofer amplifier.
Balances subwoofer loudness relative to front speakers and room effects.
Ensure all speakers are connected with the same polarity for proper sound.
Connects speaker wires from receiver outputs to subwoofer speaker level inputs.
Uses RCA cable from receiver's subwoofer output to subwoofer's line-in.
Set LOW PASS FREQUENCY to center and LEVEL to MIN initially.
Adjust LEVEL and LOW PASS FREQUENCY for natural bass response.
Adjust phase for maximum bass response and alignment with other speakers.
Check power switch, AC outlet, and fuse if the power indicator LED does not light.
Check receiver settings, connections, and front speaker wiring.
Check LEVEL control, program bass content, and front speaker sound.
Details driver, frequency response, amplification, dimensions, and weight.
Covers speaker components for five years, amplifier/electronics for one year.
Contact Advent Customer Service for repair advice and procedures.