- 7 -
SETTING THE CLOCK
1. In standby mode, hold the SHIFT and press the
CLOCK button.
5. Press the SET/PAUSE button.
6. Press the SKIP / buttons to adjust the hour.
7. Press the SET/PAUSE button.
To see the time display:
Hold the SHIFT and press the CLOCK buttons.
The time display will appear for about 3 seconds.
Notes:
The clock starts operating from 0 seconds.
(Seconds are not displayed.)
In the event of a power failure or when the AC
power lead is disconnected, the clock display will
go out.
When the AC power supply is restored, the clock
display will flash on and off to indicate the time
when the power failure occurred or when the AC
power lead was disconnected.
If this happens, follow the procedures below to
change the clock time.
You can set the clock in power on or standby
mode.
9. Press the SET/PAUSE button.
8. Press the SKIP / buttons to adjust the
minute.
2. Within 3 seconds, press the SET/PAUSE button.
3. Press the STOP button to select the time 24 hour/
12 hour format.
4. Press the SKIP / buttons to adjust date of
today MON, TUE, WED, THU, FRI, SAT or SUN.
SKIP SKIP
STANDBY
STOP
CLOCK
PAUSE
SHIFT
To Next Page
Loading...