EasyManua.ls Logo

Audiovox Prestige APS-57 User Manual

Audiovox Prestige APS-57
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
128-7766
1 of 2
3 Channel Remote
Car Starter
Model APS-57
Owner’s Manual
FEATURES :
2 Three Button Programmable RF Transmitters
Three Channel Receiver (capable of accepting 4 transmitters)
Keyless Entry Outputs (+) and (-)
Trunk Release Output
On-Board Start Relay
On-Board Accessory Relay
On-Board Ignition 1 Relay
On-Board Ignition 2 Relay
Ignition 2 Relay Selectable On or Off During Cranking
On-Board Parking Light Relay
Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
Tach Signal Learning Circuit
Two ( + ) and Two ( - ) Safety Shutdown Circuits
Alarm By-Pass Output
Accessory Outputs
(Pulse Before & After Start, During Crank & After Shut Down)
Selectable Steady or Flashing Parking Lights for Run Indication
Selectable 5, 10, 15, 20 Minute Run Time
Selectable 1 Sec., 3.5 Sec., or 1 Sec./Dbl 1 Sec. Door Lock Output Pulse
Car Finder Mode

Other manuals for Audiovox Prestige APS-57

Question and Answer IconNeed help?

Do you have a question about the Audiovox Prestige APS-57 and is the answer not in the manual?

Audiovox Prestige APS-57 Specifications

General IconGeneral
TypeRemote Starter
Keyless EntryYes
Alarm SystemNo
Number of Buttons4
CompatibilityMost vehicles with automatic transmission
Engine StartYes
Security SystemNo
InstallationProfessional installation recommended
Battery LifeUp to 1 year

Summary

Keyless Entry and Remote Car Finder

Keyless Entry Operation

Lock and unlock vehicle doors using the transmitter buttons. Parking lights flash to confirm actions.

Remote Car Finder

Locate your vehicle by pressing and holding transmitter buttons, activating parking light flashes.

Remote Trunk Release and Starting

Remote Trunk Release

Open the electric trunk by pressing and holding the Key/Trunk button on the transmitter for 4 seconds.

Remote Starting the Vehicle

Start the vehicle remotely via the Key/Trunk button, with safety conditions and run cycle options.

PRLED Safety Control Switch

Service Mode Activation

Temporarily disable remote starting by activating the PRLED switch, indicated by flashing LEDs.

Exiting Service Mode

Return the system to full functionality by deactivating the PRLED switch via a specific button sequence.

Related product manuals