128-8707
2 of 2
2
After removing the two #0 point
phillips screws shown, pry
apart case with the edge of a
finger nail or a small common
screwdriver. Keep hold of the
metal key ring loop to prevent it's
loss as it will separate from the
transmitter case.
Carefully remove the
discharged battery by sliding it
out from under the clip in the
direction indicated by the arrow
in the diagram. Properly dispose
of the exhausted battery and
insert a new CR2032 taking
care to arrange it so that the +
is facing up toward the +
symbol on the battery clip.
Reassemble in the reverse of
above.
This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions.
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.
NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment
To Next Page
Loading...
Need help?
General
