How to use AU Focus AF-2KW/5KW-ML LCD Controller
1. To switch the unit on and off: short press the power button once to power on and short
press it again to power off.
2. To switch to temperature mode - Whilst the unit is turned ON: press and hold the power
button for 3 seconds to switch from “heating mode” to “air conditioning mode” – This simply
allows you to control the room temperature in air condition mode or the amount of heat that
comes out of the unit in heating mode.
● In heating mode: Press the up and down keys to adjust the heater setting from P1
through to P5.
● In the air conditioning mode, Press the up and down keys to adjust the
temperature from 10℃ to 35℃，
3. The following functions are entered by long pressing the power button while the unit is
off:
Note: when you reach the desired function let go of the power button, then you will remain in
the current option.
Fist option: Display “ON” (Normal start)
Second option: Display “Po” (Pump oil start) : Automatic oil pump start: release the power
button and ignition plug, fan will start ,pump will pump oil after around 1 minute. After the fuel
line is full, the unit will automatically ignite and enter the normal combustion state. (If the fuel
unit is not full on the first attempt, it will display “Po”, then short press power button again and
it will start to pump diesel again to prime and fire up.
To Next Page
Loading...