Step 22.
Some models include a voltage meter option available on the wiring harness close to the unit.
This simply displays the voltage and amps that the unit is drawing whilst in operation.
There are 3 options for using this.
a) keep it close to the unit as per the image below it’s, been double sided taped
to the rear side of the unit.
b) Use the 1.5m extension cable and mount it where you like within 1.5m.
c) Use the small bypass plug provided and do not use the voltage meter.
Note:
1. One of the above options must be taken. The unit will not receive power if there is nothing
plugged into the voltage meter outlet. The voltage meter will simply display the current voltage
the unit is currently receiving and displays the amps it is drawing in real time.
Step 23.
Press the power on the LCD to make sure it turns on and then press it again to turn it off.
Note: This is just to make sure you have power.
Step 24.
Put Diesel into the fuel tank.
Step 25.
Prime the fuel using the “User Manual” provided.
Note: DO NOT OVER PRIME FUEL AS THIS WILL CAUSE EXCESS SMOKE FROM THE EXHAUST.
To Next Page
Loading...