English
1 )
enter pairing mode.
2 ) Enable the Bluetooth function on your computer. Select “Devices
and Printers” from the Control Panel and click “Add a device” to
start scanning for new devices. After the scan finishes, “Ms425”
will appear in the results.
3 ) Double click the “MS425” icon to connect to the speaker. The system
will install the MS425 driver automatically. (Code: 0000)
4 ) When successfully connected, the MS425 will say "Bluetooth" and
the status LED will light blue.
5 ) To output sound from your computer to the MS425, select “Sound”
from the Control Panel; then select the MS425 and click “Set Default”.
All sound from your computer will now be played by the MS425.
6 ) The MS425 automatically attempts to reconnect to the last paired
device after it is switched on. To disconnect and pair the MS425 with
a new device, press and hold for 2 seconds to force the MS425
into pairing mode.
Press and hold the Power button until the status LED flashes blue to
The MS425 is able to control the music playing on either a mobile phone
or a computer with a Bluetooth connection.
Use Volume Control on the MS425 to adjust volume.
Press or to select the previous or next track and press to
play/pause/resume.
Note:
These functions depend on the music player on your mobile phone or
computer.
<<
<<
Whilst connected to your mobile phone, the MS425 will act as a
hands-free system for any calls. Press on the MS425 to pick up or
hang up calls. Press and hold for 2 seconds to reject the incoming
call.
Plug the 3.5mm audio cable into the Line In socket. The MS425 will
enter Line In mode automatically. In Line In mode, the status LED is a
solid red.
Removing the audio cable will return the MS425 to Bluetooth mode
automatically.
To charge the MS425, connect the micro USB lead to the device’s power
socket, and the other end of the USB cable to a powered USB port.
The charging LED lights red whilst charging and turns off once the battery
is fully charged.
When the power is low, the MS425 gives a warning beep every 20 seconds.