NOTICE for use!
This document is only valid with the latest operation instructions attached to the device, the attached declaration
of incorporation as well as the pertaining technical data sheets. They are understood as reference documents.
Purpose of the document:
The present document informs about the actions required for using the device in safety-related systems in
accordance with IEC 61508 or IEC 61511.
Reference documents:
●
exida report no. AUMA 15/10-108 R014 and AUMA 12/02-079 R007
●
Operation instructions (Assembly, commissioning) and Technical data for gearbox
Reference documents are available on the Internet at: http://www.auma.com.
Table of contents Page
31. Terminology............................................................................................................................
31.1. Abbreviations and concepts
52. Application and validity.........................................................................................................
52.1. Range of application
52.2. Standards
52.3. Valid device types
63. Architecture, configuration and applications......................................................................
63.1. Architecture (gearbox sizing)
63.2. Configuration (setting)
63.3. Protection against uncontrolled operation (self-locking/brake)
63.4. Operation mode (low/high demand mode)
63.5. Further notes and indications on architecture
63.6. Applications (environmental conditions)
84. Safety instrumented systems and safety functions...........................................................
84.1. Safety functions
95. Installation, commissioning and operation.........................................................................
95.1. Installation
95.2. Commissioning
95.3. Operation
95.4. Lifetime
95.5. Decommissioning
106. Tests and maintenance..........................................................................................................
106.1. Safety equipment: check
106.2. Proof test (verification of safe gearbox function)
106.3. Maintenance
117. Safety-related figures.............................................................................................................
117.1. Determination of the safety-related figures
128. SIL Declaration of Conformity (example).............................................................................
16Index........................................................................................................................................
17Addresses...............................................................................................................................
2
Gearboxes
Table of contents
To Next Page
Loading...
