auna Duke DAB - Page 24

24
EN
DAB radio setting
During DAB radio mode, press and hold the menu button, LCD will show
“full scan”, then press tuning down or tuning up button repeatedly to
select below:
Full scan: press select button to conrm, unit will automatically scan those
available DAB stations.
Manual tune: press select button to conrm, then press tuning down or
tuning up button to select DAB radio frequency manually, press select
button again to conrm if desired frequency is found.
DRC: press select button to conrm, press tuning down or tuning up
button repeatedly to select “o”, “low” and “hgih”, then press select button
again to conrm. The selected option will show “*” at the right side of LCD.
Prune: press select button to conrm, press tuning down or tuning up
button repeatedly to select “yes” and “no”, then press select button again to
conrm. This is used to cancel all invalid stations after full scan.
TA: press select button to conrm. Press tuning down or tuning up button
repeatedly to select “on” and “o”, then press select button again to
conrm.
System: press select button to conrm, then press tuning down or tuning
up button repeatedly to select “language”, “factory reset”, “sw version”,
“time” and “backlight”. Press select button to conrm. The selected option
will show “*” at the right side of LCD.
• “Language” is the language select of the operation interface.
• “Factory reset” is the selection to back to the factory default setting
• “SW version” for checking software version
• “Time” for setting time
• “Backlight” for setting backlight level
- On level: select from “high”, “medium” and “low”, then press select
button to conrm.
- Dim level: select from “high”, “medium” and “low”, then press select
button to conrm.
- Time out: select second from 10 > 20 > 30 > 45 > 60 > 90 > 120 > 180
Hints for better reception: DAB : put out the telescopic antenna to enhance
radio reception if necessary.
DAB radio encoding
1. Press fun button repeatedly to select “DAB” mode
2. Insert memory device (only desired device USB drive, SD or mmc card)
3. Press the REC button, it will take 3-5 seconds to read memory device.