59
EN
BT
Press the MENU button or on the remote control and device (if in FM
mode) to switch to BT mode. The display will show ‘BT Disconnected’.
Make sure that no other BT device is connected to the radio. “No
Connection "will appear on the display.
Activate BT mode on the device that you want to connect. Look for
The radio on the list of detected devices on the BT device (refer to the
instruction manual of the device). Once the devices have found each other,
the radio will appear as 'StealthBaseConnect' on the BT device.
Select 'StealthBaseConnect' from the list. If you are required to enter a
PIN code, enter 0000 (four zeros). Certain devices may also require you to
approve the connection.
Once the connection has been successful, “Connected” will appear on the
display of the radio.
Start playback on your BT device.
Control the playback from the BT device or from the radio using the Vol+/
Vol- on the device. Adjust the volume both on the BT device and the radio.
To disconnect a connected BT device: Press and hold down the Enter button
for 3 seconds. The message “No Connection” will appear on the display.
AUX IN
Connect an external audio source (e.g MP3-Player/set top box) with the
AUX-Input at the back of the device, to play the audio via the RFA2011 IR.
You can use the UP/DOWN to select the AUX/LINE IN/OPTICAL/
COAXIAL,press Enter button on the device or OK button on the remote
control to selected.
To Next Page
Loading...
Need help?
General
