Assemby Instructions for APT4300 – Aunger 4’x 3’ Trailer
13
Please complete the ’Before Road Use Checklist’ at the
back of these instructions prior to registration and road use
Your APT4300 is now fully assembled.
WARNING NOTE :-
This Trailer MUST BE Registered at the local Main Roads Authority BEFORE
Road Use. Refer to the documentation on ‘How to register your Aunger Trailer’, log
onto www.aunger.com.au or contact your local main roads authority
Always ensure the wheel nuts are tightly fastened and the connector plug is connected correctly to
allow trailer brake light, park light & indicator functions. Test to ensure all lights are in proper
working order prior to road use. Also ensure the coupling is properly connected to the 50mm tow
ball and the safety chain is attached prior to road use.
Loads
It is critical to your safety that this trailer is never overloaded beyond its design capability in such a
way to make it unsafe. All loads should be evenly distributed and secured. This trailer was not
designed to carry loads greater than
220kgs and due care and caution should be exercised when
loading weights approaching this maximum load.
To Next Page
Loading...