Assemby Instructions for APT4300 – Aunger 4’x 3’ Trailer
12
15. Attach the coupling, chain and triangle bracket to the drawbar as shown using
2 x M10*80 Hex Bolt and 2 x M10 Locknut.
Place the coupling on top of the drawbar and align the holes. Place bolt through coupling,
through chain (as shown) and through the triangle bracket underneath drawbar. Secure
with M10 Locknut underneath. Place second bolt at back of coupling through drawbar,
through triangle bracket and tighten M10 Locknut. Adjust length of chain as required, for a
shorter length, attach the bolt through another link.
Please Note: If you have any slack in the wiring, pull lighting cables loosely through
drawbar, wrap excess lighting cable through triangle bracket to prevent the cable from
dragging or sitting on the ground. Be sure to leave a small amount of slack in cables to
allow for tilt of tray.
Flip the trailer back onto its wheels. Take care to ensure all fastening points are tightened
and that all components have been used.
16. Now tests your lights, attach the trailer plug to the socket on the car and check the
following functions; brakes, indicators, parking lights and hazard lights.
To Next Page
Loading...