Assemby Instructions for APT4300 – Aunger 4’x 3’ Trailer
6
Fit the drawbar front and rear as shown. Attach drawbar to axle with 1 x hex-bolt M10x75
and locknut M10 and tighten (1). Secure drawbar latch as shown (2), insert R pin through
latch
5. Fit the lightboard as shown. In the centre of the board, use 1 x M8*15 Flange Hex Bolt
and 1 x M8 Lock Washer and tighten.
6. Once the lightboard is fitted, attach the light board supports using 2 x M6*15 Flange
Hex-Bolt, 2 x M6 Flat Washer and 2 x M6 Locknut as shown. Repeat for other side
1
2
To Next Page
Loading...