Assemby Instructions for APT4300 – Aunger 4’x 3’ Trailer
7
7. At this time, secure the black plastic tube that contains the wiring to the body of the
trailer as shown below. Simply twist these ties to secure the wire.
8. Remove the Hubnuts from the axle. Then mount a wheel on each side using 4 x M12
hubnuts (ensure tapered edge is facing in and located within hole). Make sure the black
tire valve is on the outside. Finger tighten each hubnut and then gradually tighten each
hubnut moving around the wheel until tightened hard.
9. Once the light board is attached in the centre
and you have fitted the light board supports,
turn the trailer over onto its wheels.
To Next Page
Loading...