11. DO NOT INSTALL THE DEVICE AT LOCATIONS, WHERE IT WILL BE EXPOSED TO HIGH
HUMIDITY AND DUST.
Install the device at a location, where it will be protected from high
humidity and dust. If humidity and dust attain inside the device, malfunctions may be caused.
12. MOUNT THE DEVICE AND OTHER COMPONENTS OF THE SOUND SYSTEM
SUFFICIENTLY.
Otherwise the device and components may get loose and act as dangerous
objects, which could cause serious harm and damages in the passenger room.
13. ENSURE CORRECT CONNECTION OF ALL TERMINALS. Faulty connections may could
cause fire hazard and lead to damages of the device.
14. THE MOUNTING HOLES. If you drill the mounting holes for the installation into the vehicle’s
chassis, ensure by any means, not to damage, block or tangent the fuel pipe, the gas tank, other
wires or electrical cables.
15.
DO NOT INSTALL AUDIO CABLES AND POWER SUPPLY WIRES TOGETHER.
Ensure while
installation not to lead the audio cables between the head unit and the processor together with the
power supply wires on the same side of the vehicle. The best is a areal separated installation in the
left and right cable channel of the vehicle. There with a overlap of interferences on the audio signal
will be avoided. This stands also for the equipped bass-remote wire, which should be installed not
together with the power supply wires, but rather with the audio signal cables.
16.
ENSURE THAT CABLES MAY NOT CAUGHT UP IN CLOSE-BY OBJECTS.
Install all the
wires and cables like described on the following pages, therewith these may not hinder the driver.
Cables and wires which are installed close-by the steering wheel, gear lever or the brake pedal,
may caught up and cause highly dangerous situations.
17.
DO NOT SPLICE ELECTRICAL WIRES.
The electrical wires should not be bared, to provide
power supply to other devices. Otherwise the load capacity of the wire may get overloaded. Use
therefor a appropriate distribution block. Otherwise fire hazard and risk of electric shock consists.
18. DO NOT USE BOLTS AND SCREW NUTS OF THE BRAKE SYSTEM AS GROUND POINT.
Never use for the installation or the ground point bolts and screw-nuts of the brake system,
steering system or other security relevant components. Otherwise fire hazard consists or the
driving safety will be derogated.
19.
ENSURE NOT TO BEND OR SQUEEZE CABLES AND WIRES BY SHARP OBJECTS.
Do not
install cables and wires not close-by movable objects like the seat rail or may be bent or harmed by
sharp and barbed edges. If you lead a wire or cable through the hole in a metal sheet, protect the
insulation with a rubber grommet.
20.
KEEP AWAY SMALL PARTS AND JACKS FROM CHILDREN.
If objects like these will be
swallowed, the risk of serious injuries consists. Consult promptly a medical doctor, if a child
swallowed a small object.
To Next Page
Loading...
