Introduction
Precautions
Warning
Product name: Microbubbles Shower Head, Purebble II
Materials
● Body: ABS resin
● O-ring: Silicone
● Filter: Stainless Mesh
Filter
Part Names
1
2
This user manual shows how to mount and care for the product.
Please read this carefully before using to get the most out of this product.
Please keep this on hand for reference as necessary.
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
Shower head
Microbubble
nozzle
O-ring
Transparent
intake screw
(attached)
Air inlet
Screw joint
(G1/2)
Check water temperature before using the shower to avoid being
scalded by hot water.
If you are using an instantaneous gas water heater, the water temperature
may change during your shower.
Keep the water temperature below 60. Higher temperatures will
cause damage, distortion, or discoloration of the product.
This product is made of plastic. Take care not to over tighten screws
when mounting.
Do not use for other liquids such as solvents or chemicals.
Do not use product for anything other than showering.
Use a soft cloth to clean the product. Brushes may damage the
product.
Water remaining in the shower head will drain from the air inlet when you
stop the shower.
If the water pressure is too high, reduce the water volume.
When you remove the jet panel, use a soft cloth such as a towel to prevent
slipping.
If the water pressure of your shower is high, the shower head may pop out
of the shower holder when you start t
he shower. In such case, be sure to
hold the shower head by hand or make sure it is firmly set in the holder
before turning on the shower faucet.
Prior to installing, confirm that you have all the parts listed below. If there are
any missing or different parts, please contact the store where you purchased
the product.
Body
Highest temperature for use: 60℃
Minimum water pressure: 0.035Mpa
Minimum water amount: 7L/min
Maximum service temperature: 60℃
Jet panel
O-ring
O-ring inside
Filter
To Next Page
Loading...