Care
3 4
If you do not see air bubbles when placing the shower head under water.
If water leaks from the air inlet.
Hard Water Buildup
The above issues may be caused by lime clogging the filter inside the screw
joint between the showerhead and hose. Please clean the filter using the
methods below.
* Please take care not to lose any parts when you are cleaning.
Maintenance may be required:
If the jet panel is clogged:
Due to regular
operation
Due to irregular
operation
1.Clean with baking soda
①
Prepare items
※
Remove attached O-ring in
advance
③
Add a small amount of
water on and work it into
the tiny holes in the jet panel.
②
Sprinkle a plenty of
baking soda on the panel.
④
Leave to sit for about 30
mins. Use the edge of a
toothbrush to scrub the tiny
holes on both sides.
⑤
Rince well with water and reattach to shower head.
If clogging persists, you may need to repeat the process a few times.
Jet panel
O-ring
Water
Shallow plate
Toothbrush
Baking
soda
Blockage in the filter:
When Filling the Bathtub
If it appears that the Jet Panel is clogged, we recommend the cleaning
methods below.
If there is no improvement after trying the above,use a toothpick to clean the
holes carefully from the back side,as not to damage them.
See the illustration image.
If sand or any other foreign substance sticks to the filter, thewater flow may
be reduced. In this case, remove the O-ring that fixes the filter and then
remove any blockages from the filter.
When you fill the bathtub with Purebble for a micro bubble bath, please keep
the air inlet out of the water. If the air inlet is covered by water, the shower
head will not be able to produce microbubbles.
Continue to the next page
↗
※
Water remaining in the shower head will drain from the air inlet when you stop the shower.
Regularly maintain Purebble for long term use.
To Next Page
Loading...