Choosing a Location
Note: for a new installation, choose a mounting
location about five feet (1.5 meter) above the floor
in an area with good air circulation and away from.
1. Drafts of dead air sports.
2. Air ducts.
3. Radiant heat from the sun or appliances.
4. Concealed pipes and chimneys.
2.5) Mounting the Receiver onto the
wall/junction box:
1. Remove the front cover of the Receiver. (jump to
step 4 if installed on a junction box).
2. Mark the holes position.
3. Drill two holes and insert the plastic anchors
carefully into the holes until they are flush with
the wall.
4. Connect the wires.
5. Push on the wires in the wall.
6. Fasten securely the Receiver to the wall with the
two screws.
7. Cover up the unit with the front cover and
installation is completed.
2.6) Mounting the Receiver onto the optional
wall box :
1. Remove the front cover of the Receiver.
2. Mark the holes position for the wall box.
3. Drill two holes and insert the plastic anchors
carefully into the holes until they are flush with
the wall.
4. Pull the wires into the wall box and fasten the
wall box onto the wall.
5. Connect the wires.
6. Push on the wires in the wall box.
7. Fasten securely the Receiver to the wall box with
the two screws.
8. Cover up the unit with the front cover and
installation is completed.
ARATON 2100 TX
9
To Next Page
Loading...
