14 15
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Never leave the product unattended when in use.
Do not exceed the air pressure of the connected components.
Do not place heat sources such as cooking equipment and barbecues in or near the product, this may
cause re and damage.
Do not place the product in areas subject to frequent shock or vibration. This may result in tipping over
and/or damage to the product.
Do not touch the product with wet hands, as this may cause a shock or other personal injury.
Do not touch the product during use, the product becomes hot.
Do not shine the light into the eyes of people or animals when the product is on. Do not look into the
light beam when the product is on.
Be careful when connecting and disconnecting the air pressure hose from an air pressure release
device.
Turn on the product only when the cables are properly connected. Failure to do so may result in a re
hazard, personal injury or damage to the product.
Make sure that the product is on a stable and secure surface, so that the product cannot fall over and
no water can enter.
Make sure that the ventilation system is not blocked when the product is on. This can lead to overhea-
ting. Keep at least 30 cm of space around the ventilation grid.
Electronics
Do not let the cable(s) hang over the edge of a table or countertop.
Do not place the cable(s) on hot surfaces or near oil.
Do not tuck the cable(s) under rugs or blankets. Make sure the cable is never in a walkway.
Do not move the product by pulling or twisting the cord.
Make sure you do not trip over the cable(s) and that the cable(s) are not kinked, twisted, or stuck.
Periodically inspect both power cord and plug for signs of damage or wear, and if any, do not operate
the product and have the power cord and/or plug replaced or repaired by authorized service person-
nel.
To avoid electric shock, do not use the product if you suspect that the power cord or plug is damaged.
A damaged power cord or plug must be repaired or replaced by a professional (an authorized distribu-
tor).
Use and store the product so that the cables cannot be damaged.
If the surface of the product is cracked, please turn off the product to avoid electric shock.
Never insert objects into the slots on the outside of the unit, you may hit live parts. This may cause re
and/or electric shock.
To avoid overheating, explosion, electric shock, re, other damage and personal injury, use only the
adapter and/or accessories supplied by the supplier.
Should the internal temperature control system fail, the overheating protection will automatically acti-
vate and the product will stop functioning. Unplug the product, let the product cool down completely
and restart the product.
If you are not using the product, disconnect it from the product to which it is connected.
Do not immerse the product, power cord or plug in water. If water does get inside or on the product,
turn the product off immediately and contact our customer service department.
Prevent short circuits. The jumper cables may not touch or be connected to each other. This may cause
overheating, resulting in battery/battery damage or explosion.
Jumper cables should only be used to provide additional power to the vehicle’s battery when it is low.
They should not be used to power other devices, components or living things.
Do not connect the product to engines that exceed the indicated capacity. This applies to both gasoli-
ne and diesel engines.
Batteries
Batteries must be installed according to the correct polarity as marked on the product.
Make sure the cables are connected to the battery terminals with the correct polarity. Refer to the vehi-
cle manual to conrm any requirements before performing the jumpstart procedure.
Contents of package
Auronic Jumpstarter with compressor - Model AU3197 - EAN 8720195257103
Included accessories
1x User Manual - 1x Carrying bag - 1x Air hose
1x Jumper cables - 1x Nozzle Set - 1x USB-A to USB-C cable
1x USB EU adapter (220V)
-
-
-
-
Receiving your shipment
When receiving your shipment, make sure that the contents are consistent with the packing list. Notify
your distributor of any missing items. If the equipment appears to be damaged, le a claim immediately
with the carrier and notify your distributor at once, giving a detailed description of any damage. Save
the damaged packing container to substantiate your claim.
-
Product features
Product overview
1.
2.
3.
4.
5.
6.
12.
11.
10.
9.
8.
7.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Lamp
Air supply
LCD display
On/off lamp
Mode
On/off product/pump
Ventilation grid
Plus/minus
Starter cable adapter port
15V 10A output port
USB 5V 2.4A output port
USB-C 5V 2A input port
To Next Page
Loading...