PR600M
Key
boards
Dcscriiie:
W
KWyq
fMOoHT
Key
-
Used far hiniing the calculator oo. When performing
a
caksletkm,
press once to den the last entered value. Press again to
dear di entered values, excqrt memory. This key is also used for
ckaring
the overflow
toot.
rOff
Key
-
Used for
turning
the calculator off.
-Paper Feed Key
-
Used for advancing the paper.
-Print
On/Off
Key
-
Used for
turning
the printer on and off. When
"print"
is shown on the display, entries and results
will
appear on the
display and print out. When
"print"
is not shown on the display, entries
and results
will
appear in the display, but
will
not be printed out.
—Used for
setting
Tax rate or Currency exchange rate.
-Used for calculating the Currency.
TAX-rifTAX-l
—Used for calculating the tax.
IBB""
-—Used for calculating the metric Conversion,
ICOSH
BELLI
MARGINI-—Used for calculating the cost, selling price and profit margin
amount.
Enter the value of any
2
items to drtain the remaining value.
(e.g. enter the value of the cost and the selling price to obtain the profit
tnargin%.)
Non-Add Key
-
Used for printing out infotmatkm which
does
not
_
affect the calculation such as dates and serial numbers. Figures are
_
tjurMzjESum- printed on the left-hand side
of
the
paper.
'"
PEG Deeinial Point Selector Key
-
Used for designating the decimal point
position
(F
0 2 3
4
A)
for calculated results.
A (Add-Mode)-Addition and subtraction functions are performed
with
an
automatic 2-digit decimal. This is convenient for currency
calculations. e.g. enter 123
&
"1.23" is displayed.
F
(Floating Decimal point)-All effective numbers up to 12 digits are
printed
or displayed.
OVERFLOW
FUNCTION
In
the fcdiownig casts, the "E"
will
displayed and die keyboard is electronically locked,
the
furthei
operation is impossible. Press PN/Q to clear the overflow.
Overflow Error Condition:
1.
When the calculated result
exceeds
12 digits.
2.
Dividing by "0".
3.
The sequential operation
speed
is faster
than
the calculation processing
speed.
SPECIFICATIONS
Power Source: AAx4,6V.
Adapter: 6V 300mA
Calculating Capacity: 12 digits maximum.
Automatic
Power-off: approx.
5
minutes.
Dimension:
218.6mm(L)
x
99.5inm(W)
X
46.5mm(H)
InkRoll:IR30orIR40
«
Paper Tape: Width: 57mm
%''t
Diameten UOmm (max)
If
you experience operational problems
with
the calculator, please press the "RESET'
button
at the back
of
the calculator. Afier resetting,
be
sure to set the currency exchange
and tax rate again.
REPLACING
THE INK ROLLER
1) Power off
first.
2) Remove the printer cover. (Figure
1)
3) Lift the old ink
roll
out from the
roll
holder. (Figure
2)
4)
Install
a
new ink
roll
into position. (Figure
3)
5) Replace the printer cover. (Figure
4)
INSTALLING PRINTING
PAPER
1) Remove the printer cover and
lift
up the arm. (Figure 5)
2) Place printing paper
roll
on the arm. The
edge
of the paper should be positioned as
shown.
(Figure
6)
3) Insert the
edge
of the paper into the
slit
at the back
of
the machine (Figure 7) and
ctwtinue
insetting the paper between the silver printer parts inside the mwrhine.
(Figure 8)
Turn
the calculator on.
4) Press the paper
feed
key
[J]
to advance the paper. (Figure
9)
5) Insert paper through the printer cover while replacing the printer coyer.
INSTALLING PRINTING
PAPER
INTERNALLY
If
the diameter of the paper
roll
is less
than
27mm, you can load the paper
roll
internally as
shown.
(Figure 10)
1) Remove the printer cover.
2) Insert the paper between the silver printer parts inside the machine.
3) Urm the calculator on.
4) Press the paper
feed
key
I t I
to advance the paper.
5) Insert paper through the printer cover while replacing the printer cover. The
following printing paper should be used for the orinter.
To Next Page
Need help?
General