1) Make sure the headset is off.
2) Place both devices not more than one meter away from each other.
3) Press the power bu
on on le ar cup about 8-10s un ll the LED light
(between the power bu on and the microphone) alternately flashes blue
and red. This indicates that the headset has entered pairing mode.
4) Ac
vate Bluetooth on your phone and set it to search for new devices.
5) Select the “AUSDOM M04”to pair, once successfully paired, the
headset blue LEDs will be on con
nuously.
6) If paring failed a er 60 seconds, please repeat steps 1 through 5
described above.
6) As soon as the system detects the new device and you see “AUSDOM
M04”,then select the “AUSDOM M04”to pair.
7) If your computer ask you to enter the PIN code=0000(4 zero). You will be
asked to enter a PIN code, please use “0000”.Once successfully paired, the
headset blue LEDs will be on con
nuously.
8) If paring failed a er 60 seconds, please repeat steps 1 through 7
described above.
To Next Page
Loading...
Need help?
General
