Auta COMPACT - Functioning; Calling and Conversation; Self-Starting Communication; Calling to Concierge

calling and conversation
When a call is received from the entrance panel, the phone starts ringing for a maximum of 30 seconds. As standard, it
performs 4 rings with intervals of 4 seconds between each of them.
During the call period, the user can open directly by pressing the button , or pick up the handset to establish a
conversation. The conversation has a maximum of 90 seconds. If you want to continue with the conversation, press the
button
AUX 1/ON
Functioning
EN
self-staing
By pressing the button the user can establish communication with the PANEL. In the case of more than one panel
is present in the installation the system will do the self-starting to the last one from which it receives a call.
Once the communication is established, an opening can be made by pressing the button
AUX 1/ON
calling to concierge
If the phone is in standby, handset is picked up and the button is pressed, a call will be made to the concierge unit.
If the system does not have a concierge unit installed, the phone will emit an error beep.
ding dong function
The phone allows to replace the interior bell of the house, this integrates the two calls (outside panel and house bell) in a
single device. These calls will be dierentiated with dierent melodies and lashes automatically. In order to have this
function, you only have to connect the button of the house bell to the phone.
external functions
The phone has 1 independent push-button that allow auxiliary functions, such as garage doors, lights, irrigation, etc ...
To do this, an Auta auxiliary relay must be connected to the control circuit we want to control.
PANIC call
The telephone allows the connection of as many push-buttons as required in the housing, which when pressed will send
a panic call to a CCI central. If the line is busy, the phone will memorise the call and send it when it detects that it has
become free, automatically. No need to press again.
The function must be activated following the table of special functions that appears on the last page of the manual.
To receive a panic call, the CCI central must have this function enabled in its “Coniguration” menu.
adjust of the calling volume
To adjust the volume of the call, insert a clip or similar through the indicated hole and press with it lightly.
The phone has two volume levels (MEDIUM and HIGH)
melody selection
To select a ring tone, you have to pick up the handset and press the hang switch with your inger. With it pressed, a clip
or similar must be inserted in the indicated hole and press with it lightly.
Each press selects a dierent melody from 8 ones available.