Need help?Do you have a question about the Autel ATS100 and is the answer not in the manual?
General| Model | ATS100 |
|---|---|
| Connectivity | USB |
| Protocols | Unspecified |
| Power Supply | Rechargeable battery |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Storage Temperature | -20°C to 70°C (-4°F to 158°F) |
| Dimensions | Unspecified |
| Weight | Unspecified |
Compact, rugged 77 GHz millimeter wave radar for blind spot warnings on heavy-duty trucks and buses, featuring IP69K protection.
Precision detection system providing dynamic alerts and display-based intelligent warnings to reduce collision probability and driver fatigue.
Integrates gyroscope, accelerometer, and GPS for essential input signals without needing vehicle speed, acceleration, or yaw rate.
Details on connecting the radar, display, and GPS/IMU module harnesses, emphasizing proper connector attachment.
Guidelines for mounting the radar on a low-vibration component, ensuring optimal detection performance and avoiding blockages.
Instructions for routing the radar cable into the cabin along with the chassis cable, requiring cabin lifting for access.
Explains two input signal options: using the supplied GPS/IMU module or vehicle CAN signals (J1939).
Recommends connecting the radar to KL15 or terminal 15 (12V or 24V) on the main fuse board for power supply.
Guidance on placing the GPS/IMU module horizontally in the cabin, preferably behind the windscreen, and securing it.
Procedure for mounting the display assembly on the bracket backplate, allowing angle adjustment and secure fastening.
Describes using the AutelRadarCfgTools to generate a PDF report with vehicle information, radar serial number, and installation details.
To Next Page
