9-15
FITTED EQUIPMENT
The operating pressure for the gas supply is
30 mbar and must correspond to the
operating pressure of the appliance (see
name plate).
The gas system must be inspected every two
years by a qualified GAS SAFE specialist.
The vehicle keeper is responsible for
arranging this inspection.
During the initial operation of a brand new
appliance (or after it has not been used for
some time), a slight amount of fumes and
smell may be noticed for a short while. This
can be remedied by running the heater
immediately at maximum output and ensuring
adequate room ventilation.
If the burner makes an unusual noise or if the
flame lifts off while burning, it is likely that the
regulator is faulty, and it is essential to have it
checked.
If the vehicle floor is given a body underseal,
all parts of the heater located under the
vehicle must be covered up so that the
underseal spray does not impede the
operation of the heater system. The covers
must be removed again when the work is
finished.
To Next Page
