9-21
FITTED EQUIPMENT
covers should be fitted. This protects the unit
from excessively cold air which could have
adverse effects on the performance of the
unit.
Note: The winter covers should also be
attached if the vehicle is taken out of service
for an extended period, or while it is being
cleaned on the outside.
Failure display
Your refrigerator will indicate a malfunction by flashing of the failure indicator LED (4) and one of
the other display lights. The chart below shows the meaning of these.
Display: Failure:
LED is flashing 230V mode: “230V” not available or voltage too low
LED is flashing 12V mode: “12V” not available or voltage too low
LED is flashing GAS/Auto mode: Flame not ignited
All temperature setting Temperature sensor defective, refrigerator work
LEDs are flashing on mid temperature setting
LED + all temperature 230V - Heating element defective
LED + all temperature 12V - Heating element defective
setting LEDs are flashing
To Next Page
