Need help?Do you have a question about the AutoAqua Smart ATO Lite and is the answer not in the manual?
General| Model | Smart ATO Lite |
|---|---|
| Type | Auto Top Off System |
| Pump Type | DC Pump |
| Power Supply | AC Adapter |
| Maximum Pumping Height | 1.5 m |
| Water Level Sensor | Optical Sensor |
| Pump Flow Rate | 1.5 L/min |
| Tank Size Compatibility | Up to 200L |
| Max. Mounting Thickness | 15 mm |
| Operating Temperature | 0-40°C |
Auto Top Off with Dual Sensors, max mounting thickness 1/2 inch.
Universal Power Supply.
For rimmed or rimless aquariums up to 1/2 inch.
Pump with a head of 8.2 ft (250 cm).
A connector to break the siphon.
Tubing used with the DC refill pump.
Mount dual sensors at the normal water level using the magnet.
Connect tubes to the pump and siphon break, securing the water tube.
Connect the DC pump and power adapter to the controller and then connect power.
Caution regarding risk of injury from strong magnets during installation.
Flashing alternating blue and red LEDs indicate the boot-up status.
Covers solid (power on), flashing (refilling), and fast flashing (fail-safe sensor) states for the blue LED.
Flashing red LED indicates QST alarm for bubble interference or empty reservoir.
Overview of the controller and dual sensors used in the QST system.
To Next Page
