AutoAqua Smart ATO micro User Manual

Smart ATO micro FAQ AUG. 2018 v.2
Copyright ©2018 AUTOAQUA Technologies Co., Ltd. All rights reserved
Smart ATO micro FAQ
1. How to set up the siphon break properly?
2. Are drops of water from the siphon break a normal phenomenon
when the pump’s on?
3. What will happen if the siphon break is not set up properly?
4. Why is the head height not high enough?
5. Is there an alert when the reservoir is empty?
6. Can Smart ATO micro still work if the glass is not transparent?
7. How does the redundancy work for the Smart ATO micro?
8. Why is the water level always a little higher than the sensor? Is the
sensor broken?
9. Why does the red LED flash with audible alert? I have checked the
water reservoir and the bubble but there is no problem.
10. How to use other pumps with Smart ATO micro?
11. How to extend the cable length of the pump/solenoid valve/power
supply?
12. Can I use the solenoid valve with Smart ATO micro? How to install it?
13. How to purchase accessories?

AutoAqua Smart ATO micro Specifications

General

Type	Auto Top Off System
Model	Smart ATO Micro
Pump Type	DC Pump
Water Level Sensor	Optical Sensor
Power Supply	100-240V AC 50-60Hz
Compatibility	Freshwater
Flow Rate	280 LPH (74 GPH)
Power Input	12V DC
DC Pump	Included
Max. Head	6.5 ft (200 cm)
Mounting Thickness	Up to 0.5"
Operating Temperature	0-40°C
Hose Length	6.5 ft (200 cm)
Pump Flow Rate	280 L/H

Summary

Smart ATO micro FAQ

Proper Siphon Break Setup Guide

Detailed guide on correctly installing the siphon break to prevent siphoning.

Normal Water Dripping from Siphon Break

Explains that water drops from the siphon break hole are normal when the pump is active.

Impact of Incorrect Siphon Break Installation

Details issues like overfilling if the siphon break is improperly placed or oriented.

Optimizing Pump Head Height for ATO

Addresses reasons for insufficient head height and recommends proper pump placement.

Low Reservoir Alert System Explained

Explains how the Quick Security Technology (QST) alerts users to an empty water reservoir.

ATO Functionality with Opaque Tanks

Confirms functionality with non-transparent tanks as the sensor is internal.

Smart ATO Micro Redundancy Features

Describes the QST feature preventing overfilling by monitoring refill times.

Troubleshooting High Water Level vs. Sensor

Lists reasons for higher water levels and provides steps to test sensor functionality.

Resolving Red LED Flash and Audible Alerts

Guides on resolving red LED/audible alerts by checking QST memory and sensor placement.

Integrating Third-Party Pumps with ATO

Instructions for using other pumps with the Smart ATO micro via the Smart AC Socket.

Extending ATO Component Cable Lengths

Details available extension cable options for pumps, solenoid valves, and power supplies.

Solenoid Valve Installation for ATO

Explains how to use and install a solenoid valve with the Smart ATO micro for RO/DI systems.

Acquiring Smart ATO Micro Accessories

Provides information on locating local distributors for purchasing accessories.