579-1241AC Rev A
TrueAlert ES Addressable US/Weather Proof Ceiling Mount Speaker Notification Appliances
Installation Instructions
*05791241ACA*
Cautions, warnings, and regulatory information
Important: When the notification appliance emits light or sound, it indicates the possibility of an emergency situation that requires immediate atten-
tion of all occupants.
SAFETY: Always install, maintain, and test notification appliances within their specifications. Failure to follow all safety precautions and
instructions may result in loss of life and property due to non-functioning notification appliances. Some notification appliances use high
voltage. To avoid electrical hazards and avoid damage to appliances, make sure that the electrical power for the Notification Appliance
Circuit is disconnected at the control panel before installing, repairing, or internally adjusting any notification appliances. Even with
electrical power removed, some notification appliances (such as visible strobes) store a high voltage charge. The high voltage can cause
injury resulting in death from electrical shock. DO NOT TOUCH EXPOSED CIRCUITRY.
LOCATION REFERENCE: Location and quantity of appliances required must conform to the applicable local standards and guidelines
(the National Fire Alarm and Signaling Code (NFPA 72); ULC Standard CAN/ULC-S524, Installation of Fire Alarm Systems; the appropriate
model building codes, etc.) and specific requirements of the Local Authority Having Jurisdiction (AHJ). These notification appliances are
not intended for installation within hazardous locations as defined by the National Electrical Code (NEC) or NFPA.
UL listed TrueAlert ES indoor product identification reference
Table 1: Product Identification Reference
Type
Cover
colors
Models Operation
Figure 1: Ceiling
Mount
Speaker/
Visible(S/V)
with cover
• Red
• White
Components:
A49SVH-APPLC-O
A49SVH-APPLC-O
Covers:
A49SVC-CRALT-O
A49SVC-CRFIRE-O
A49SVC-CRS-O
A49SVC-CRBC-O
A49SVC-CWBC-O
A49SVC-CWFIRE-O
A49SVC-CRFEU-O
A49SVC-CRBF-O
A49SVC-CWALT-O
A49SVC-CWBA-O
A49SVC-CRBA-O
A49SVC-CWS-O
A49SVC-CWBF-O
A49SVC-CWFEU-O
A49SVC-CK-O
Back boxes:
A49WPBB-SVCR
A49WPBB-SVCW
Figure 2: Ceiling
MountS
peaker
Only (SO)
with cover
• Red
• White
Components:
A49SO-APPLC-O
A49SO-APPLC-O-BA
Covers:
A49SOC-CW-O
A49SOC-CR-O
A49SOC-CWALT-O
A49SOC-CRALT-O
A49SOC-CRFIRE-O
A49SOC-CRS-O
A49SOC-CWFIRE-O
A49SOC-CWS-O
A49SOC-CK-O
Back boxes:
A49WPBB-SOCR
A49WPBB-SOCW
These appliances provide an
audible (SO) or audible/visible (S/
V) warning of an alarm condition
when activated from the control
panel of a compatible UL/ULC
Listed, Autocall Fire Alarm
System. Consult Autocall Fire
Alarm panel documentation for
compatibility information. The
speakers can be turned ON/OFF
individually under compatible
panel control.
Kit contents: Appliance x1, with 1.25 inch thread forming screws (#8-16 thread) x 4.
Not included: Order a back box to mount the appliance assembly to the ceiling. Order a cover separately for each appliance.
Note: For information about TrueAlert ES appliance testing consult TrueAlert ES Addressable Appliances Troubleshooting (579-1049AC).
Strobe operation levels
The A49 S/V appliances have multiple strobe intensity levels. Levels W135, W110, and W185 are rated for UL outdoor private mode applications. Level
110 is rated for UL indoor and uncontrolled wet Public Mode applications.
To Next Page
Need help?
General