To Next PageTo Next Page
Need help?Do you have a question about the AutoGate VPG-24 (LM) and is the answer not in the manual?
General| Brand | AutoGate |
|---|---|
| Model | VPG-24 (LM) |
| Category | Gate Opener |
| Language | English |
Describes the internal entrapment sensing system.
Describes provisions for external entrapment sensors.
Details the primary inherent entrapment protection mechanism.
Explains the entrapment alarm activation and reset.
Defines key terms and components of the VPG system.
Covers site inspection, planning, and conduit requirements.
Details requirements and options for concrete pad installation.
Lists essential tools and equipment for installation.
Provides guidance on safe receiving and unpacking of the system.
Step-by-step guide for installing the gate and operator.
Instructions for safely lifting the gate and operator assembly.
Details on positioning the gate and operator on the concrete pad.
Instructions for installing cable wind bracing for gate stability.
Instructions for installing masted wind bracing for gate stability.
Information on installing the gate guard for safety.
Instructions for attaching the kick panel to the operator.
Discusses critical entrapment zones and safety measures.
Steps for connecting the required batteries for power.
How to test the operator's basic functions.
Instructions for connecting the AC power supply to the unit.
Details the electrical connection of the outlet and switch.
Configuration of timers and mode selections on Switch Pack S1.
Configuration of mode selections on Switch Pack S1 (6-8).
Configuration of timers and mode selections on Switch Pack S2.
Wiring instructions for primary and secondary gate systems.
Installation of loops and detectors for safety and functionality.
Installation steps for photoelectric sensors.
Wiring instructions for keypad installation.
How to check battery status and charging system.
Troubleshooting steps when the gate fails to close.
Troubleshooting steps when the gate fails to open.
Diagnosing issues when the IRD LED is flashing.
Troubleshooting blown fuses and potential causes.
How to operate the gate manually during power failure.
Lists the necessary tools for spring changes.
Details of the slide assembly related to spring changes.
Procedures for checking and adjusting gate balance.
Steps for replacing the control board.
Illustrates common conduit run configurations for the operator.
Lists potential conduit types for the operator.
Illustrates common conduit run configurations for the operator.
Lists potential conduit types for the operator.
