11
© 2007 directed electronics, inc.
To enter or exit Valet
®
Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet®
switch within 10 seconds.
The status LED will light steadily if you are entering Valet
®
Mode and will turn off if you are exiting Valet
®
Mode.
One Time Bypass
The one-time bypass feature is used only when the passive/auto
rearm (feature 1) is turned on. It prevents the system from
arming itself automatically one time by cycling the ignition key
to the on position for 2 seconds then back off. The LED will
stop flashing rapidly to confirm.
panic mode
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter. Just
press for two seconds to enter Panic Mode. In Panic Mode,
the horn will honk and the parking lights will flash for 30
seconds. To stop Panic Mode at any time, press on the
transmitter again.
note: In order for Panic Mode to be effective, the vehicle’s
horn (or optional siren) must be connected.
➜
➜
To Next Page
Loading...
Need help?
General