Automatic Systems CL 636 - Programming and System Analysis

p. 21/24
The informaon contained in this document is the property of Automac Systems and is condenal. The recipient shall refrain from using this informaon for any purpose other than the
use of the products or the execuon of the project to which it refers and from communicang it to third pares without prior wrien agreement of Automac Systems. The document is
subject to change without noce.
CL 636-MT-EN

Automac Systems.
Automac Systems

Automac Systems
service.

In order to work the soware needs the following kit:





The minimum required to install is:



Installing the «Power Console» program.



Automac Systems technical assistance service.
Automac Systems
Automac Systems assistance service.
ATTENTION:




3. PROGRAMMING AND ANALYSIS.