EasyManua.ls Logo

AutoMeter Invision 7006 - Page 13

AutoMeter Invision 7006
13 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 MONTH LIMITED WARRANTY
AutoMeter Products, Inc. warrants to the consumer that all AutoMeter High Performance products purchased from an Authorized AutoMeter Reseller will be free from defects in material and workmanship for a period of
twelve (12) months from date of the original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at AutoMeter’s option, when determined by AutoMeter that the product failed due to
defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the AutoMeter High Performance product and the necessary labor done by AutoMeter to effect the repair or replacement
of the AutoMeter High Performance product. In no event shall AutoMeter’s cost to repair or replace an AutoMeter High Performance Product under this warranty exceed the original purchase price of the AutoMeter High
Performance Product. Nor shall AutoMeter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of an AutoMeter High Performance Product. This warranty
applies only to the original purchaser of the AutoMeter High Performance Product and is non-transferable. This warranty also applies only to AutoMeter High Performance Products purchased from an Authorized
AutoMeter Reseller. All implied warranties shall be limited in duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized
repairs or alterations voids this warranty. AutoMeter disclaims any liability for consequential damages due to the breach of any written or implied warranty on all products manufactured by AutoMeter Products, Inc. For a
comprehensive listing of Un-Authorized AutoMeter Resellers please visit www.autometer.com/autometerlocator/index/unauthorized.
FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 (866) 248-6356
For Email: Service@autometer.com
© 2021 Auto Meter Products. Inc. 7/21/21 2650-2032-77 Rev. A
SERVICE
For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. If you are sending product
back for warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.
Available Items From Auto Meter that you may want or need:
#5291 3-wire Hall Effect speed sender. This is a pass through unit and can be used if your vehicle still have cable operated cruise
control. It can still be used as a stand alone unit if you no longer use a cable.
#5293 2-wire Sine Wave speed sender (generator). This is a more economical unit, and does not provide as many pulses as the 5291,
and does not require power to operate. Only signal and ground.
#5289 GPS Interface Module. This works great if you have a situation where your transmission has no mechanical output, or no
existing speed sender. This simply requires power & ground, and has a signal output. The included GPS antenna is magnetic, and can
be mounted inside the vehicle, or outside.
#5284 LS Install Kit. If you are performing an installation with an LS based engine, you can order this kit for the needed adapters, and
LS specic instructions.
#9123 LS Tach Adapter Kit. Sometimes with the LS conversion, the tachometer signal becomes lost. This kit will allow you to install a
tachometer adapter, and is specically designed to plug into the factory LS ignition harnesses located at the center of each valve cover.
The wire harness portion of this works for most LS applications up to 2013.
#9117 Tachometer Adapter. This can be wired in by the installer if the above 9123 will not work for your application.
#3227 -4an Braided Stainless Steel Hose Kit. This is a 3’ long hose kit that some would use to relocate their oil pressure sender in the
event that you want to mount it off of the engine elsewhere. Other lengths are also available.
Auto Meter offers a variety of hose adapters that allow you to install your temperature sender into a hose directly. Available in different
sizes, ranging from 5/8”, up to 1-1/2”. Model numbers 2280, 2281, 2282, & 2283.
***6 Pin Connector Image