To Next PageTo Next Page
Need help?Do you have a question about the Automotive Integrated Electronics USBCDPLAY1 and is the answer not in the manual?
General| Brand | Automotive Integrated Electronics |
|---|---|
| Model | USBCDPLAY1 |
| Category | CD Player |
| Supported Disc Formats | CD, CD-R, CD-RW |
| USB Port | Yes |
| MP3 Playback | Yes |
| WMA Playback | Yes |
| Anti-Skip Protection | Yes |
| Remote Control | Yes |
Guidelines for correct mounting orientation and angle to ensure proper functionality.
Ensures correct horizontal mounting with CD slot on top and eject button arrow pointing up.
Ensures correct vertical mounting with CD slot facing up and unit perfectly straight.
Avoid mounting upside down, on sides, or at angles less than zero degrees.
Locate a spot for the CD player, ideally without needing USB extension cables.
Mount vertically or horizontally using provided tape on a stable, flat surface.
Connect the CD player's USB to a data USB port, not a power-only port.
Wait for the indexing process (up to 20 seconds) to create a table of contents for playback.
Once indexing is complete, you can control song selection with FF, REW, PLAY/PAUSE.
Check the Vehicle Fit Guide and Factory Requirements for radio compatibility.
Ensure connection to a data USB port and try direct connection without extensions.
Wait for indexing (20 seconds) and avoid interrupting the process to prevent errors.
Eject disc, insert different disc to purge USB hub, then reinsert original CD.
