Do the flushing procedures as above until to exhaust the
detergent. Then stop engine and reconnect the vacuum
pipe.
Start engine as idle speed for about 5 to 10 minutes to
exhaust the detergent in the pipe.
●
●
6
The operating procedure of Throttle body and exhaust
pipe flushing:
Pour the Throttle Body detergent into the bottle, and
close the Ball Valve of the fuel outlet pipe. Open the ball
valve of the air inlet port and connect to the compressed
air. Adjust the air pressure to about 0.5MPa ( 5kgf/cm2 )
and then close the Ball Valve of air inlet port.
Connect the spray nozzle kit to the fuel outlet port of the
C100.
●
Remove the pipe ahead of throttle before flushing as
shown.
●
●
To Next Page
Loading...