Note
The connection ways for carburetor fuel system is same
to electronic fuel injection system. The pressure in
carburetor fuel system must be 0.07~0.35 kgf/cm2.
4
THE PICTURES
Pour the mixture of gasoline and detergent into steel
bottle of the C100.
Close the valve of C100’s fuel-outlet pipe and open the
valve of C100’s air-inlet port and then connect to the
compress air. Adjust the pressure of air within 0.3 to
0.4MPa ( 3 to 4kgf/cm2 ) by air control valve.
Connect the fuel supply adaptor of C100 to fuel supply
pipe of the car fuel system, and open the ball valve.
Check if it has some leaking between all the connec-
tions. There must have no any leaking when doing the
cleaning work.
Start engine to start flushing the fuel system.
Drain out the pressure in the C100’s bottle after flushing,
and then disconnect the C100.
Restore all of the pipes of the fuel system and check
there have no leaking.
●
●
●
●
●
●
To Next Page
Loading...