Headquarters
1080 W Entrance Dr
Auburn Hills, MI 48326
Assembly
561 S Fairfield Ave
Juneau, WI 53039
seal strip installation Guide
installation
The Litter-Robot 3 is equipped with brush-type Seal Strips that sit
on the Base under the Globe and help contain odor within the Waste
Drawer.
Replace the Seal Strips when they are worn flat or peeling. You can
make them last longer by trimming loose edges between replacements.
Seal Strips are not required for the unit to function.
Replacement Seal Strips can be ordered at www.litter-robot.com.
1. Press the Power button to turn the unit o, then
unplug the unit.
2. Remove the Bonnet and Globe.
For complete instructions, see the Manual or visit
https://www.litter-robot.com/owners-manual.html.
3. On the Base, peel o the old Seal Strips and
discard. Remove any leftover adhesive with a
cotton ball and rubbing alcohol. Make sure the
surface is dry and free of oils and litter debris
before installing new seals.
4. Plan the layout of all four Seal Strips, starting
from the corner closest to the Control Panel.
5. Peel back 3-4 inches of the protective backing
from the adhesive of one seal and begin placing
it along the rib, making sure to curve the strip
with the Base. Press down firmly and remove
the backing as you go.
6. If the Seal Strip overlaps any grooves or
recesses, trim the ends with scissors.
7. Reassemble the Globe and Bonnet, then plug
the unit in and turn it on.
Properly installed Seal Strips
When cleaning the Base, be careful not to wet the Seal
Strips or they may begin to peel.
To maintain the Seal Strips, use a lint roller or vacuum to
remove debris.
Tips
Visit www.litter-robot.com for installation videos.
Start here
Contact Customer Service
Monday - Friday, 9am - 5pm EST
1-877-250-7729 or support@litter-robot.com
LR3-8155
To Next Page
Loading...
