2
1a
Your new automatic pool cleaner contains:
- The robotic pool cleaner with its floating cable.
- The Power Supply (transformer).
- Cart (optional)
Operating the Pool Cleaner
Please read this manual completely before operating your pool
cleaner.
Place the power supply (transformer) at least three meters / ten feet
from the pool.(fig.1). The transformer will supply low voltage to the
cleaner.
Uncoil the cable.(fig.1a)
For proper operation, lock the moveable handle diagonally across the
top of the cleaner's body. Push down on the handle lock mechanism
and slide the handle all the way to the end (recommended one slot
before the end), then release the lock. The handle will remain fixed in
this position. Repeat this process on the other side of the cleaner.
Remember, the handle must be fixed diagonally (fig.2a, 2b)
Place the unit in the water. Turn the unit side to side in the water to
allow air to escape from the body and then let the cleaner sink to the
bottom of the pool (fig.3). Then, spread the cable over the surface of
the pool as evenly as possible (fig.1).
Plug the cable into the power supply. Make sure the key on the plug
exactly corresponds with the key slot on the socket of the power
supply (fig.1b).
Plug the power supply into a grounded outlet. Ensure that the electric
outlet has been properly grounded (fig.1c). The light will glow indicating
that the system is “ ON “ and the pool cleaner will start the cleaning
cycle. The unit keeps record of the number of cleaning cycles. Only an
authorized service center can display the accumulated cleaning cycles.
(See details on the next page)
WARNING: A Ground Fault Current Interrupter (GFCI-USA) or a Residual Current Device
(RCD-EUROPE) must be installed to protect your electric outlet and prevent any possible
electric shock.
1
3
1c
1b
2a
2b
To Next Page
Loading...
Need help?
General